Multi-master replication means that you can write to any node and be sure that the write will be consistent for all nodes in the cluster. This is different from regular MySQL replication, where you have to apply writes to master to ensure that it will be synced.
With multi-master replication any write is either committed on all nodes or not committed at all. The following diagram shows how it works for two nodes, but the same logic is applied with any number of nodes in the cluster:
All queries are executed locally on the node,
and there is special handling only on
COMMIT query is issued,
the transaction has to pass certification on all nodes.
If it does not pass, you will receive
ERROR as the response for that query.
After that, the transaction is applied on the local node.
COMMITincludes the following:
Applying the transaction on remote nodes
does not affect the response time of
because it happens in the background after the response on certification.
There are two important consequences of this architecture:
Several appliers can be used in parallel.
This enables truely parallel replication.
A slave can have many parallel threads configured
There might be a small period of time when a slave is out of sync. This happens because the master may apply events faster than the slave. And if you do read from the slave, you may read the data that has not changed yet. You can see that from the diagram.
However, this behavior can be changed
by setting the
In this case, the read on the slave will wait until the event is applied
(this will obviously increase the response time of the read).
The gap between the slave and the master is the reason
why this replication is called virtually synchronous replication,
and not real synchronous replication.
The described behavior of
COMMIT also has another serious implication.
If you run write transactions to two different nodes,
the cluster will use an optimistic locking model.
This means a transaction will not check on possible locking conflicts
during the individual queries, but rather on the
and you may get
ERROR response on
This is mentioned because it is one of the incompatibilities
with regular InnoDB that you might experience.
LOCK TIMEOUT errors usually happen
in response to a particular query, but not on
It is good practice to check the error codes after a
but there are still many applications that do not do that.
If you plan to use multi-master replication
and run write transactions on several nodes,
you may need to make sure you handle the responses on
For general inquiries about our open source software and database management tools, please send us your question and someone will contact you.