Installing Percona XtraDB Cluster on Debian or Ubuntu

Percona provides .deb packages for 64-bit versions of the following distributions:

  • Debian 7 (“wheezy”)
  • Debian 8 (“jessie”)
  • Ubuntu 12.04 LTS (Precise Pangolin)
  • Ubuntu 14.04 LTS (Trusty Tahr)
  • Ubuntu 16.04 LTS (Xenial Xerus)
  • Ubuntu 18.04 LTS (Bionic Beaver)
  • Ubuntu 18.10 (Cosmic Cuttlefish)


Percona XtraDB Cluster should work on other DEB-based distributions, but it is tested only on platforms listed above.

The packages are available in the official Percona software repository and on the download page. It is recommended to install Percona XtraDB Cluster from the official repository using apt.


You need to have root access on the node where you will be installing Percona XtraDB Cluster (either logged in as a user with root privileges or be able to run commands with sudo).

Make sure that the following ports are not blocked by firewall or used by other software. Percona XtraDB Cluster requires them for communication.

  • 3306
  • 4444
  • 4567
  • 4568

If MySQL Is Installed

If you previously had MySQL installed on the server, there might be an AppArmor profile which will prevent Percona XtraDB Cluster nodes from communicating with each other. The best solution is to remove the apparmor package entirely:

$ sudo apt-get remove apparmor

If you need to have AppArmor enabled due to security policies or for other reasons, it is possible to disable or extend the MySQL profile.

Dependencies on Ubuntu

When installating on a Ubuntu system, make sure that the universe repository is enabled to satisfy all essential dependencies.

See also

Ubuntu Documentation: Repositories

Installing from Repository

  1. Configure Percona repositories as described in Percona Software Repositories Documentation.

  2. Install the Percona XtraDB Cluster server package:

    $ sudo apt-get install percona-xtradb-cluster-57


    Alternatively, you can install the percona-xtradb-cluster-full-57 meta package, which contains the following additional packages:

    • percona-xtradb-cluster-test-5.7
    • percona-xtradb-cluster-5.7-dbg
    • percona-xtradb-cluster-garbd-3.x
    • percona-xtradb-cluster-galera-3.x-dbg
    • percona-xtradb-cluster-garbd-3.x-dbg
    • libmysqlclient18

    During installation, you will be prompted to provide a password for the root user on the database node.

  3. Stop the mysql service:

    $ sudo service mysql stop


    All Debian-based distributions start services as soon as the corresponding package is installed. Before starting a Percona XtraDB Cluster node, it needs to be properly configured. For more information, see Configuring Nodes for Write-Set Replication.

Next Steps

After you install Percona XtraDB Cluster and stop the mysql service, configure the node according to the procedure described in Configuring Nodes for Write-Set Replication.