Buy Percona ServicesBuy Now!

High Availability

In a basic setup with 3 nodes, Percona XtraDB Cluster will continue to function if you take any of the nodes down. At any point in time, you can shut down any node to perform maintenance or make configuration changes. Even in unplanned situations (like a node crashing or if it becomes unavailable over the network), the Percona XtraDB Cluster will continue to work and you’ll be able to run queries on working nodes.

If there were changes to data while a node was down, there are two options that the node may use when it joins the cluster again:

  • State Snapshot Transfer (SST) is when all data is copied from one node to another.

    SST is usually used when a new node joins the cluster and receives all data from an existing node. There are three methods of SST available in Percona XtraDB Cluster:

    • mysqldump
    • rsync
    • xtrabackup.

    The downside of mysqldump and rsync is that your cluster becomes READ-ONLY while data is being copied (SST applies the FLUSH TABLES WITH READ LOCK command).

    SST using xtrabackup does not require the READ LOCK command for the entire syncing process, only for syncing .frm files (the same as with a regular backup).

  • Incremental State Transfer (IST) is when only incremental changes are copied from one node to another.

    Even without locking your cluster in read-only state, SST may be intrusive and disrupt normal operation of your services. IST lets you avoid that. If a node goes down for a short period of time, it can fetch only those changes that happened while it was down. IST is implemeted using a caching mechanism on nodes. Each node contains a cache, ring-buffer (the size is configurable) of last N changes, and the node is able to transfer part of this cache. Obviously, IST can be done only if the amount of changes needed to transfer is less than N. If it exceeds N, then the joining node has to perform SST.

You can monitor the current state of a node using the following command:

SHOW STATUS LIKE 'wsrep_local_state_comment';

When a node is in Synced (6) state, it is part of the cluster and ready to handle traffic.

Visit Percona Store


General Inquiries

For general inquiries, please send us your question and someone will contact you.