Installing RPM packages using yum

If you are running an RPM-based Linux distribution, use the yum package manager to install PMM Client from the official Percona software repository.

Percona provides .rpm packages for 64-bit versions of Red Hat Enterprise Linux 6 (Santiago) and 7 (Maipo), including its derivatives that claim full binary compatibility, such as, CentOS, Oracle Linux, Amazon Linux AMI, and so on.

Note

PMM Client should work on other RPM-based distributions, but it is tested only on RHEL and CentOS versions 6 and 7.

To install the PMM Client package, complete the following procedure. Run the following commands as root or by using the sudo command:

  1. Configure Percona repositories using the percona-release tool. First you’ll need to download and install the official percona-release package from Percona:

    sudo yum install https://repo.percona.com/yum/percona-release-latest.noarch.rpm
    

    Note

    If you have previously enabled the experimental or testing Percona repository, don’t forget to disable them and enable the release component of the original repository as follows:

    sudo percona-release disable all
    sudo percona-release enable original release
    

    See percona-release official documentation for details.

  2. Install the pmm2-client package:

    yum install pmm2-client
    
  3. Once PMM Client is installed, run the pmm-admin config command with your PMM Server IP address to register your Node within the Server:

    pmm-admin config --server-insecure-tls --server-url=https://admin:admin@<IP Address>:443
    

    You should see the following:

    Checking local pmm-agent status...
    pmm-agent is running.
    Registering pmm-agent on PMM Server...
    Registered.
    Configuration file /usr/local/percona/pmm-agent.yaml updated.
    Reloading pmm-agent configuration...
    Configuration reloaded.
    
Edit this page: .md.rst

Table Of Contents

Previous topic

Installing DEB packages using apt-get

Next topic

Using PMM Client