Preparing a Full Backup with innobackupex

After creating a backup, the data is not ready to be restored. There might be uncommitted transactions to be undone or transactions in the logs to be replayed. Doing those pending operations will make the data files consistent and it is the purpose of the prepare stage. Once this has been done, the data is ready to be used.

To prepare a backup with innobackupex you have to use the --apply-log and the path to the backup directory as an argument:

$ innobackupex --apply-log /path/to/BACKUP-DIR

and check the last line of the output for a confirmation on the process:

111225  1:01:57  InnoDB: Shutdown completed; log sequence number 1609228
111225 01:01:57  innobackupex: completed OK!

If it succeeded, innobackupex performed all operations needed, leaving the data ready to use immediately.

Under the hood

reading the configuration from the files in the backup directory,

innobackupex replayed the committed transactions in the log files (some transactions could have been done while the backup was being done) and rolled back the uncommitted ones. Once this is done, all the information lay in the tablespace (the InnoDB files), and the log files are re-created.

This implied calling xtrabackup –prepare twice with the right binary (determined through the xtrabackup_binary or by connecting the server). More details of this process are shown in the xtrabackup section.

Note that this preparation is not suited for incremental backups. If you perform it on the base of an incremental backup, you will not be able to “add” the increments. See Incremental Backups with innobackupex.

Other options to consider

The --use-memory option

The preparing process can be speed up by using more memory in it. It depends on the free or available RAM on your system, it defaults to 100MB. In general, the more memory available to the process, the better. The amount of memory used in the process can be specified by multiples of bytes:

$ innobackupex --apply-log --use-memory=4G /path/to/BACKUP-DIR
© Copyright 2010-2012, Percona Ireland Ltd.
Except where otherwise noted, this documentation is licensed under the following license:
CC Attribution-ShareAlike 2.0 Generic
Created using Sphinx 1.2.2.
This documentation is developed in Launchpad as part of the Percona XtraBackup source code.
If you spotted innacuracies, errors, don't understood it or you think something is missing or should be improved, please file a bug.