Search Results for: myisam insert select performance

InnoDB Full-text Search in MySQL 5.6: Part 2, The Queries!

This is part 2 in a 3 part series. In part 1, we took a quick look at some initial configuration of InnoDB full-text search and discovered a little bit of quirky behavior; here, we are going to run some queries and compare the result sets. Our hope is that the one of two things […]

InnoDB Full-text Search in MySQL 5.6 (part 1)

I’ve never been a very big fan of MyISAM; I would argue that in most situations, any possible advantages to using MyISAM are far outweighed by the potential disadvantages and the strengths of InnoDB. However, up until MySQL 5.6, MyISAM was the only storage engine with support for full-text search (FTS). And I’ve encountered many […]

Adventures in archiving

One of our Remote DBA service clients recently had an issue with size on disk for a particular table; in short this table was some 25 million rows of application audit data with an on disk size of 345GB recorded solely for the purposes of debugging which may or may not occur. Faced with the task of […]

Impact of the sort buffer size in MySQL

The parameter sort_buffer_size is one the MySQL parameters that is far from obvious to adjust. It is a per session buffer that is allocated every time it is needed. The problem with the sort buffer comes from the way Linux allocates memory. Monty Taylor (here) have described the underlying issue in detail, but basically above […]

Paul McCullagh answers your questions about PBXT

Following on from our earlier announcement, Paul McCullagh has responded with the answers to your questions – as well as a few I gathered from other Percona folks, and attendees of OpenSQL Camp. Thank you Paul! What’s the “ideal” use case for the PBXT engine, and how does it compare in performance?  When would I […]

Just do the math!

One of the most typical reasons for performance and scalability problems I encounter is simply failing to do the math. And these are typically bad one because it often leads to implementing architectures which are not up for job they are intended to solve. Let me start with example to make it clear. Lets say […]

Detailed review of Tokutek storage engine

(Note: Review was done as part of our consulting practice, but is totally independent and fully reflects our opinion) I had a chance to take look TokuDB (the name of the Tokutek storage engine), and run some benchmarks. Tuning of TokuDB is much easier than InnoDB, there only few parameters to change, and actually out-of-box […]